Rug & Fabric Carpet Spotter II

Item Number: 2660-0936


U.S. Department Of Labor

Occupational Safety And Health Administration


Required Under USDL Safety And Health Regulations

(29 CFP 1910.1200 "Hazards Communication Standard")


Section I

Manufactured For: Gabriel First Corp.

Emergency Telephone:  1-800-424-9300

Address: 233 W Commercial Street East Rochester, NY 14445

Chemical Name & Synonyms: N/A

Trade Name & Synonyms: Rug and Fabric Spotter II

Prepared On: 04/26/2005



1 0 0 B


Section II - Product & Component Data

Component(s) CAS % PEL TLV

Chemical Names Registry No

Deionized Water 7732-18-5 65-75 NA NA

Primary Alcohol Ethoxylate NE <2.0 NA NA

Trisodium Phosphate 7601-54-9 <5.0 400ppm400ppm

2-Propanol 67-63-0 10-20 400ppm400ppm

Propylene Glycol t-Butyl Ether 57018-52-7 5-15 NE NE

Liquified Petroleum Gas 68476-85-7 5-10 1000 1000


Section III - Physical Data

Boiling Point: NA

Specific Gravity (H2O=1): <1.0

Vapor Pressure: 85-90@130 F

Percent, Volatile By Volume(%):

Vapor Density(Air=1):>1

Evaporation Rate: <1

Solubility In Water: Complete.

Appearance And Odor: Clear, slightly hazy liquid, with mild odor.



Section IV - Fire And Explosion Hazard Data

Special Fire Fighting Procedures: Containers should be kept cool with water to prevent vapor pressure build up. Use equipment or shielding, as required, to protect personnel from bursting, rupturing or venting containers..

Flash Point/Method Used: 85F

Flammable Limits: N/A

Extinguishing Media: Water.

Unusual Fire and Explosion Hazards: At elevated temperatures (over 54C-130F) containers exposed to direct heat or flame or heat contact should be cooled with water to prevent weakening of container structure.


Section V - Health Hazard Data

Effects Of Overexposure:

Eyes: May cause irritation or possible damage to the tissue if not promptly removed.

Skin: Frequent or prolonged contact may irritate may irritate and cause dermatitis.

Inhalation: Coughing, shortage of breath, dizziness and intoxication.

Ingestion: Moderately toxic.

Emergency First Aid Procedures:

Eyes: Flush immediately with water for at least 15 minutes while lifting the upper and lower lids. Call a physician.

Skin: Remove contaminated clothing. Flush skin with water, follow with soap and water. Do o t reuse clothing until cleaned.

Inhalation: Remove subject to fresh air and administer oxygen if breathing is difficult. Call a physician.


NOTE TO PHYSICIAN: There is no specific antidote. Treatment should be directed at the control of the symptoms and the clinical condition.


Section VI - Reactivity Data

Stability Conditions To Avoid

Stable Do not store above 54C-130F. Keep away from heat, direct sunlight, open flames or sparks.

Dropping of containers may cause bursting.

Materials To Avoid: Oxidizing Agents

Hazardous Decomposition Products: Carbon Dioxide and additional toxic chemicals may be formed in small amounts.

Hazardous Polymerization Conditions To Avoid

Will not occur None


Section VII - Spill Or Leak Procedures

Steps To Be Taken In Case Material Is Released Or Spilled: Remove sources of heat, flames, or sparks. Provide adequate ventilation. Wipe up spills. Rinse with water to remove slippery residue.

Waste Disposal Method: Replace cap and discard container in trash. Do not puncture. Dispose of in accordance with local, state and federal regulations.


Section VIII - Special Protection Information

Respiratory Protection(Type): None required.

Ventilation: Adequate ventilation.

Protective Gloves: Plastic gloves.

Eye Protection: Safety glasses/goggles.

Other Protective Equipment: N/A


Section IX - Special Precautions

Precautions To Be Taken In Handling And Storing: Warning: contents under pressure. Keep out of reach of children. Flammable. Keep in a cool, dry, locked area away from flames, sparks & other sources of heat & ignition. Do not spray on or towards eyes or face. Avoid breathing spray vapors.

Other Precautions: Keep out of reach of children. Read entire label before using.



This information is given in good faith, but no warranty expressed or implied is made. Our company believes that it is accurate to the best of its knowledge and relates only to the specific material designated herein