MATERIAL SAFETY DATA SHEET

Required Under USDL Safety And Health Regulations

(29 CFP 1910.1200 "Hazards Communication Standard")

Section I

Manufactured For: Gabriel First Corp.

Emergency Telephone: 1-800-424-9300

Address: 233 W Commercial Street East Rochester, NY 14445

Trade Name & Synonyms: Stick-Em Traps

Chemical Family: Hot Melt Adhesive

Prepared On: 07/17/2005

Section II - Product & Component Data

Component(s)/ Chemical Names CAS Registry No % PEL TLV STEL

A HOT MELT ADHESIVE MIXTURE - NO CAS NUMBER

This product would not be considered toxic as defined by the Federal Hazardous Substance Act or the Dept. of Transportation.

Section III - Physical Data

Boiling Point: N/A

Specific Gravity (H₂O=1): 0.93

Vapor Pressure: N/A

Percent, Volatile By Volume(%):N/A

Vapor Density(Air=1): N/A

Evaporation Rate: Negligible

Solubility In Water: Insoluble

Appearance And Odor: Clear to pale yellow tacky solid.

Characteristic Odor: Petroleum odor.

Section IV - Fire And Explosion Hazard Data

Special Fire Fighting Procedures: None

Flash Point/Method Used: 400’F

Flammable Limits: LEL: N/A UEL: N/A

Extinguishing Media: Chemical Foam, CO2.

Section V - Health Hazard Data

Effects Of Overexposure: None at ambient temperatures. Excessive high temperatures may cause irritation vapors.

Emergency First Aid Procedures:

Remove to fresh air. If burn involvement due to skin contact with molten material treat with thermal burn procedures.

Section VI - Reactivity Data

Stability Conditions To Avoid

Stable N/A

Materials To Avoid: N/A

Hazardous Decomposition Products: N/A

Hazardous Polymerization Conditions To Avoid

Will not occur N/A

Section VII - Spill Or Leak Procedures

Steps To Be Taken In Case Material Is Released Or Spilled: Material is a solid adhesive. The material will not flow out. If recovery is not feasible, add mix with dry soil, sand or non reactive absorbent and place in a container or dumpster pending disposal. Shovel spilled material into empty, dry container for later disposal or recovery. Wash down affected area to remove material from surface of floor.

Waste Disposal Method: Landfill or incinerate in accordance with local, state and federal regulations.

Section VIII - Special Protection Information

Respiratory Protection(Type): Not required under normal conditions. For emergency situations use self contained breathing apparatus with pressure demand mode.

Ventilation: Not Required

Protective Gloves: Rubber gloves; latex rubber. Contact with hot materials, wear thermal resistant gloves and arm protection.

Eye Protection: Splash proof eye goggles. Where contact may occur with hot materials, wear a face shield.

Other Protective Equipment:

Section IX - Special Precautions

Precautions To Be Taken In Handling And Storing: Keep in cool, dry ventilated storage areas. Handle in well ventilated areas.

This information is given in good faith, but no warranty expressed or implied is made. Our company believes that it is accurate to the best of its knowledge and relates only to the specific material designated herein.